• Hose I.D.: 3/8 in
• Length: 18 in
• Length: 46 cm
• Inlet(M): 1/4 NPT
• Outlet(F): 1/4 NPT
• Maximum Working Pressure: 300 PSI
• Working Temperature Range: -40 to 100 °C
Material(s):
• Cover: Nitrile (type C2)
• Tube: Nitrile (type C)
• Reinforcement: Braided high tensile textile cord
• Fittings: Brass
• Lightweight and flexible
• Excellent oil resistance
• Using a hose whip between the air tool and coupler will extend the life of the coupler by acting as a shock absorber and protecting it against tool vibrations
• A hose whip allows the user an easier and wider range of motion, reducing user fatigue while increasing productivity
TECH TIP
All sharp bends on hose lines should be avoided. These tend to shorten hose life, increase pressure drops, slow down swivel action, increase pump load, and raise the temperature of the fluid. A hose whip should be installed to avoid straining on hose and coupler assembly.
• All sharp bends on hose lines should be avoided. These tend to shorten hose life, increase pressure drops, retard swivel action, increase pump load and raise the temperature of the fluid. A hose whip should be installed to avoid straining on hose and coupler assembly
• Hose I.D.: 3/8 in
• Length: 18 in
• Length: 46 cm
• Inlet(M): 1/4 NPT
• Outlet(F): 1/4 NPT
• Maximum Working Pressure: 300 PSI
• Working Temperature Range: -40 to 100 °C
Material(s):
• Cover: Nitrile (type C2)
• Tube: Nitrile (type C)
• Reinforcement: Braided high tensile textile cord
• Fittings: Brass
• Lightweight and flexible
• Excellent oil resistance
• Using a hose whip between the air tool and coupler will extend the life of the coupler by acting as a shock absorber and protecting it against tool vibrations
• A hose whip allows the user an easier and wider range of motion, reducing user fatigue while increasing productivity
TECH TIP
All sharp bends on hose lines should be avoided. These tend to shorten hose life, increase pressure drops, slow down swivel action, increase pump load, and raise the temperature of the fluid. A hose whip should be installed to avoid straining on hose and coupler assembly.
• All sharp bends on hose lines should be avoided. These tend to shorten hose life, increase pressure drops, retard swivel action, increase pump load and raise the temperature of the fluid. A hose whip should be installed to avoid straining on hose and coupler assembly
